Concepteur de solutions ATEX et industrielles
Contact : +33 (0) 4 88 78 21 81

VIXLU linear luminaire stainless steel Series

luminaire atex inox vixlu

VIXLU luminaire
in Stainless steel for fluo tubes – Zone 1

  • 1 or 2 tubes variant : 18W or 36W
  • EOL Protected
  • Mechanically very robust
  • Extremely lightweight
  • Fast, safe and easy fluorescent tube change
  • Anti-light pollution flat glass
  • Multi-voltage double channel electronic reactor

Increased safety lighting fixtures Stainless Steel series for bi-pin fluorescent tubes feature an IP66 fixture with an AISI 304 stainless steel (AISI 316L on request) body and a tempered shock and high temperature-resistant glass diffuser. This construction method makes them ideal for applications where greater protection is needed against chemically aggressive substances or where there is an elevated risk of accidental physical damage such as in certain areas of the chemical or pharmaceutical industries. They are also ideal for use in paint booths or even more specifically for use in areas where specialised electronic components are made for the aerospace industry. They are recommended for use in highly corrosive environments and in areas where water and dust are present or where there are severe variations in climate. Fluorescent tubes that reach the end of their working lives are monitored and turned off by the EOL (End of Life) safety system in compliance with EN 60079-7. If one of the two tubes stops working, the double channel multi-voltage electronic ballast allows the other to continue working independently. The lighting fixture is closed with 6 clips for the 18W version and 8 clips for the 36W. The clips keep the protective glass hooked to the body of the lighting fixture, making maintenance easier and speeding up fluorescent tube replacement.

Construction

Stainless steel AlSl304 body. Tempered glass diffuser. Closing system with stainless steel clips. Silicone gaskets. Internal frame/reflector in steel white painted. Standard voltage 110/240Vac/dc 50/60Hz. Electronic double channel ballast. Cable gland type REB1IB and two plugs type PLG1IB.

Mechanical characteristics

Body:
Diffuser:
Hinge mechanism:
Hinge:
Gasket:
SS internal reflector:
Bolts and screws:
Ground screw:
Entries:
Mounting:
AISI 304 stainless steel
Shock and high temperature resistant tempered glass
Stainless steel clips
Stainless steel and polyamides secured to the glass and light body
Acid/hydrocarbon resistant silicone
Painted white steel
Stainless steel
Stainless steel
3 Ø20.5 entries
2 M8 threaded holes

Electrical characteristics

Lamp holder:
Ballast:
Rated voltage:
Rated frequency:
Connection:
Power factor:
Wiring:

Non-sparking and multi-voltage G13 bi-pin
Double channel electronic with EOL protection
110/240 V AC/DC 50/60 Hz
Directly to the L, N, Pe terminal block 4mm
2 cross-section, terminal block with jumper suitable for input-output
0.96
Silicone rubber cables with glass braid protection against high temperatures

NOUS TROUVER

A2S (Advanced Safety Solutions) 350 Avenue JRGG de la Lauzière 31 Parc du Golf - CS 90519 13593 Aix en Provence Cedex 3

NOUS CONTACTER

Tél: +33 (0)4 88 78 21 81 Fax: +33 (0)4 42 16 35 09 E-mail : contact@a2s-antec.com
Contact par email
Formulaire de contact
Contact par téléphone
HAUT DE PAGE